Recirculating heaters are designed for 80% thermal efficiency for indoor application with gravity venting. They are certified to use with natural or propane gas, in sizes ranging from 75,000 to 400,000 BTU input.
Heater Standard Features:
Aluminized steel heat exchanger
Aluminized steel burners with stainless steel insert
120-volt supply voltage
24-volt control voltage transformer
High limit safety cutout
Single-stage combination gas valve
Side access for burners and controls
Horizontal or vertical flue discharge\
Manual match-lit pilot\
Energy cut-off device\
Blocked vent shut-off system
DR-1000 Recirculation Heater Unit
Horizontal Heating Unit with 300,000 BTU, 60 degree F temperature rise, Indirect natural gas fired heat exchanger including all gas controls, electric ignition pre-wired,
Duct Thermostat
Recirculation Duct work designed for the drying enclosure
Purge Timer Control Panel NEMA-12 with necessary
switches
Assembly hardware for the heater and ductwork
Rail Mounted unit for easy installation
Inlet register with filter frame
Discharge register
The above heater unit is designed to be mounted on top of the DR-1000 Drying Room. The heater is designed to maintain the booth enclosure to approximately 120-140 degrees F, accelerating drying time and thus increasing production. After the heater is shut off, the blowers will continue to run to purge the enclosure.
REQUEST A QUOTE | CONTACT US
Spray Systems, Inc. 1363 East Grand Avenue Pomona, CA 91766 Toll Free: (800) 736-6944
Phone: (909) 623-6944 Fax: (909) 622-6267 Email: sales@spraysystems.comCopyright © 2001
Spray Systems, Inc. All Rights Reserved.